Max HN65J Uživatelský manuál

HN65J HIGH PRESSURE METAL CONNECTOR NAILER INDEX 1. SAFETY INSTRUCTIONS ...42. SPECIFICATIONS & TECHNICAL DA

DRIVING DEPTH ADJUSTMENT DIAL LWAYS disconnect air supply before adjustment dial. WARNING: A AdjustmentWith air pressure set, drive nails into a re

13 5. MAINTAIN FORX DO NOT FIRE EN IT IS EMPTY Y USE RECOMM n e let with the jet oiler. (RecommZ INSPECT AND M EFORE OPERATION WARNING: Disconn

http://www.maxusacorp.com (USA Site) http://www.max-ltd.co.jp/int/ (

According to the European Norm EN 792-13 theregulation is valid from 01.01.2001 that allfastener driving tools with contact actuation mustbe marked wi

1. SAFETY INSTRUCTIONS WARNING: TO AVOID SEVERE PERSONAL INJURY OR PROPERTY DAMAGE BEFORE USING THE TOOL, READ CAREFULLY AND UNDERSTAND THE FOLLOWI

8. INSPECT SCREW TIGHTNESS Loose or improperly installed screws or bolts cause accidents and tool damage when the tool is put into operation. Inspect

18. WHEN USING THE TOOL OUTSIDE OR ELEVATED PLACE When fastening roofs or similar slanted surface, start fastening at the lower part and gradually wo

2. SPECIFICATIONS 1. NAME OF PARTS Frame Cylinder Cap Contact Arm Nose Magazine Trigger Grip Exhaust Cover Trigger Lock Dial Aiming

WARNING: 3. AIR SUPPLY AND CONNECTIONS Read section titled "SAFETY INSTRUCTIONS". DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESS

4. INSTRUCTIONS FOR OPERATION Read section titled "SAFETY INSTRUCTIONS". 1. BEFORE OPERATION X Wear Safety Glasses or Goggles. Y Do no

NAIL LOADING Open the Magazine: Pull up Door Latch and swing Door open. Swing Magazine Cover open. Door Latch 65 mm (2-1/2”) 40 mm (1-1/2”) When

TEST OPERATION X Adjust the air pressure at 170 p.s.i. (12 bar) and connect the air supply. Y Without touchingPull the Trigger. (ThZ With the tool