Max GS865E Uživatelský manuál stáhnout pdf (Strana 21)

Pusher Holder

Pull the Pusher Holder as far as the rear and of the magazine and release it gently.

●

Never put your face above the tool. Recoil of the tool may cause an

unexpected injury.

●

Never bring your hand or finger close to the discharge outlet.

WARNING:

q Press Contact Arm against the object.

w Pull the Trigger.

HOW TO DRIVE THE PINS

Procedure

Set the Battery and Fuel Cell in place.

Press Contact Arm against where you want to drive the pins.

The fan motor is activated, the fuel gas is jetted, mixing the fuel with the air.

Firmly pressing the Contact Arm, pull the Trigger. The pinls are driven into the object

by combustion of the fuel.

●

Prior to starting work, be sure to check whether the tool functions as

mentioned above.

●

If the tool is used for a long time, it could be heated and burn you.

If any abnormality is found, contact your nearest MAX authorized distributor

for inspection and repairing.

※

The fan keeps running for approx. 10 seconds even after driving the pins.

WARNING:

The pins are not fired again even if the Contact Arm is applied to the object with the

Trigger pulled. Release the Trigger and repeat Step

REMOVING THE PIN

Put your finger on the Pusher, pull it slightly to the rear, and then, let it back gently.

Set the Magazine vertical and push the Pin Stopper to remove the Pin.

Pin Stopper

Pusher

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Žádné komentáře

Max GS865E Uživatelský manuál Strana 21